工业工程

工业工程

• 实践与应用 • 上一篇    下一篇

基于价值流及仿真分析对于回转支承生产线的改善

  

  1. 安徽工业大学 1.管理科学与工程学院，安徽 马鞍山 243032； 2.机械学院，安徽 马鞍山 243032
  • 出版日期:2016-12-31 发布日期:2017-02-22
  • 作者简介:童华刚（1992-），男，安徽省人，硕士研究生，主要研究方向为精益生产.
  • 基金资助:

    安徽省教育厅人文社科重点资助项目（SK2016A0168）；安徽省社科联社会科学创新发展课题资助项目（A2015070）

The Improvement of Rotary Bearing Production Line Based on Value Stream Mapping and Simulation

  1. 1. School of Management Science and Engineering, Anhui University of Technology, Maanshan 243032, China; 2. Mechanics Institute, Anhui University of Technology, Maanshan 243032, China
  • Online:2016-12-31 Published:2017-02-22

摘要：

利用价值流对传统的机械加工厂进行分析，发现其物流混乱以及生产线平衡率较低等问题，利用精益生产的方法，制定改善方案。针对价值流只能静态短时间内反映生产情况，本文将价值流与Flexsim软件结合，以弥补价值流缺陷。与传统通过规划设计未来价值流不同，本文利用仿真软件确定价值流图各个工序之间的间隔时间以及超市容量。

关键词: 精益生产, 价值流, 系统仿真, 生产线平衡

Abstract:

Value stream mapping is used to analyze traditional machinery factory. Lots of problems like confusion of logistics and imbalance of the production line are found. After that, lean production is adopted to deal with these problems. However, only a period of time in factory can be described by value stream mapping. Flexsim is a key point in dealing with shortcomings of value stream mapping. After analysis of lean production, scenario of improvement can be verified by Flexsim. A final scenario would be established by a statistic report of Flexsim and lean skills.

Key words: lean production, value stream map, simulation；line balancing